Skip to main content

Zero2 XYZ Probe

(No reviews yet)

The Zero2 probe comes pre-wired with magnetic ground for your spindle and is compatible with most CNC controllers (xPRO, BlackBox, DuetWifi, and the Shapeoko).

For this iteration, we made this probe slightly larger for easier positioning on your work piece.

We also added a hole… Rather than entering in the bit diameter and the measurements of the probe into your sender, simply lower your mill end into the hole and run the macro. The macro & CNCJS do the rest, finally positioning the end mill on the front left hand side of your work piece. 


*Note the hole probing only works with CNCJS, which can be found here:

 **Note, this probe can still be used in the usual way for X/Y/Z probing.


The CNCJS macro is provided with purchase.